When you fit lens on camera, camera body needs to know if lens was set right. After that camera start check AF chip. Canon has 2 ways to do this. The first way is to close 2 >especial contact electrodes on bayonet. The second way is to push the sensor pin which is hidden in the camera body under mount. If AF chip was pushed and the shutter was pressed without AF chip, camera body is not working good. All manufactures of Confirm Adapters cut petal pusher for it doesn’t push the sensor pin. But when you fit the chip, the petal pusher should be full size. Lets do it!

	To tick place for drill on Confirm Adapter by eye. Don’t copy from this photo!
	Drill hole 3-4 mm(0.12-0.16 inch) depth. Use drill with diameter 0.6-0.8 mm(0.02-0.03 inch).
	You need superglue and solid copper wire
	Paste in copper wire in drilled hole
	Cut unnecessary copper wire. You need just 1-1.5mm (0.04- 0.06 inch).
	That’s all!

You need to do this for next camera bodies only:

• EOS 33V
• EOS 50E
• EOS A2
• EOS 3
• EOS 5
• EOS 100
• EOS 1000N
• EOS 620 (650)
• EOS D30
• EOS D60
• EOS 1D / MK II / MK III
• EOS 1DS / MK II / MK III
• EOS 1N
• EOS 1V
• All digital and film EOS 1